1. <button id="wi9py"></button>
  2. <tbody id="wi9py"><pre id="wi9py"></pre></tbody>
    1. <rp id="wi9py"><object id="wi9py"><input id="wi9py"></input></object></rp>
      <span id="wi9py"></span>
        1. 新聞中心

          NEWS CENTER

          • PCB分板機常見的故障現象及處理方法
          • 本站編輯:杭州億協智能裝備有限公司發布日期:2021-04-09 17:36 瀏覽次數:

          1.如電源開關翻開后指示燈不亮:一種可能是保險絲熔段,需改換保險絲;另一種可能是緊急開關未打開。

          2.行程不準:一種可能是行程計數器壞,需改換;另一種可能是行程計數器灰塵太多,清算灰塵即可。

          3.刀撞左側板:一種可能是左行程光感開關壞,需改換;另一種可能是左行程開關灰塵太多,清算灰塵即可。

          4.刀撞右側板:一種可能是右行程光感開關壞,需改換;另一種可能是右行程開關灰塵太多,清算灰塵即可。

          5.電機轉動,刀不轉:連軸器頂絲松動,翻開后殼,頂緊頂絲即可。

          EXE 880F_副本.png

          PCB分板機訂購,分板機廠家,推薦杭州億協智能裝備!

          1. if the indicator light is not on after the power switch is turned on: one is fuse fuse section, and the other may be that the emergency switch is not on.

          2. inaccuracy of travel: one may be that the travel counter is bad and needs to be changed; the other may be that the travel counter has too much dust, so it can be cleared.

          3. knife hitting left board: one is that the left travel light sensor switch is broken and needs to be changed; the other may be that the left travel switch has too much dust, so it can be cleaned.

          4. knife hitting right board: one may be that the right travel light sensor switch is broken and needs to be changed; the other may be that the right travel switch has too much dust, so it can be cleaned.

          5. motor rotation, knife does not rotate: the top wire of coupling is loose, open the rear housing and tighten the jacking wire.



          国产在线官网_九九综合久久_国产精品自在线拍国产_迪丽热巴白丝高潮喷水